Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
d. Remove the shims from the pressure palate.
2. REMOVE ROTOR
a. Using SST, remove the snap ring.
SST 95994-10020
NOTE: At the time of reassembly, please refer to the following item.
The snap ring should be installed so that beveled side faces up.
b. Using a plastic hammer, tap the rotor off the shaft.
NOTE: Be careful not to damage the pulley when tapping on the rotor.
3. REMOVE STATOR