Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
NOTE:
-
Do not use tools like screwdriver to remove the tube.
-
Cap the open fittings immediately to keep moisture or dirt out of the system.
HINT:
At the time of installation, please refer to the following item.
-
Lubricate 2 new O-rings with compressor oil and install them to the tubes.
-
After connection, check the fitting for claw of the piping clamp.
3. DISCONNECT SUCTION TUBE FROM COOLING UNIT FITTINGS
Loosen the nut and disconnect the both tube.
Torque: 32 N.m (330 kgf.cm, 24 ft.lbf)
NOTE: Cap the open fittings immediately to keep moisture or dirt out of the system.
HINT: At the time of installation, please refer to the following item.
Lubricate a new O-ring with compressor oil and install them to the tube.
4. REMOVE 2 GROMMETS
5. REMOVE DRAIN PIPE GROMMET
6. REMOVE GLOVE COMPARTMENT PARTS
7. REMOVE No.4 HEATER TO REGISTER DUCT