Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
Canister Purge Solenoid: Testing and Inspection
VSV FOR EVAPORATIVE EMISSION (EVAP)
INSPECTION
1. REMOVE VSV
a. Disconnect the connector and 2 EVAP hoses.
b. Remove the screw and VSV.
2. INSPECT VSV
a. Inspect the VSV for open circuit.
Using an ohmmeter, check that there is continuity between the terminals.
Resistance: 30 - 34 ohms at 20 °C (68 °F)
If there is no continuity, replace the VSV.
b. Inspect the VSV for ground.
Using an ohmmeter, check that there is no continuity between each terminal and the body.
If there is continuity, replace the VSV.
c. Inspect the VSV operation.