toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 130 > < Initial Inspection and Diagnostic Overview|Page 128
Page 3
background image

14 - GROUND

: Approx. 12 volts for 0.2 seconds with following operations.
: Door lock control SW locked.
: Locking the LH, RH door cylinder with key.

D15, D16, D26, D27, DOOR COURTESY SW FRONT REAR LH, RH

1 - GROUND

: Closed with door open.

D21, D22, DOOR LOCK MOTOR, DOOR UNLOCK DETECTION SW AND DOOR KEY LOCK AND UNLOCK SW LH, RH

4 - 8 (LH), 1 - 5 (RH)

: Closed with UNLOCK position

U1 (A), (B), UNLOCK WARNING SW

(A) 1 - (A) 2, (B) 1 - (B) 2

: Closed with key in cylinder.

POWER WINDOW

D15, D16 DOOR COURTESY SW LH, RH

1 - GROUND : Continuity with door open

BODY ECU

10 - GROUND

: Approx. 12 volts with ignition SW at ON position

3, 4 - GROUND : Always approx. 12 volts

P7 POWER WINDOW MASTER SW

(A) 3, (B) 1 - GROUND : Always continuity
(A) 10, (B) 9 - GROUND: Approx. 12 volts with ignition SW on and stays at 12 volts for 45 seconds after the ignition SW is turned off, but if a door is

opened in this 45 seconds period, voltage will drop to 0 volts

(A) 1, (B) 3 - GROUND : Approx. 12 volts with ignition SW at ON position and master SW at UP position
(A) 5, (B) 4 - GROUND : Approx. 12 volts with ignition SW at ON position and master SW at DOWN or AUTO DOWN position

WINDOW LOCK SW

Open with window lock SW at LOCK position

KEY REMINDER AND SEAT BELT WARNING

B6 BUCKLE SW LH

1 - 2 : Open with driver's seat belt in use

D15 DOOR COURTESY SW FRONT LH

1 - GROUND : Closed with LH door open

BODY ECU

10 - GROUND: Approx. 12 volts with ignition SW on
4 - GROUND : Always approx. 12 volts

8 - GROUND : Always continuity

Diagnostic Trouble Code Descriptions

For information regarding B, C, P, U and Manufacturer Code Descriptions - See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Descriptions

Diagnostic Trouble Code Tests and Associated Procedures

For information regarding diagnosis of all B, C, P, U and Manufacturer Codes - See: Powertrain Management/Computers and Control Systems/Testing
and Inspection/Diagnostic Trouble Code Descriptions

Initial Inspection and Diagnostic Overview|Page 130 > < Initial Inspection and Diagnostic Overview|Page 128