Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
c. Tighten the 5 screws until there is a clearance of at least 1 mm (0.04 in.) between the brush holder cover and connector
6. INSTALL REAR END COVER
a. Install the end cover with the 3 nuts.
Torque: 4.5 N.m (45 kgf.cm, 39 in.lbf)
b. Install the terminal insulator with the nut.
Torque: 4.1 N.m (42 kgf.cm, 36 in.lbf)
7. CHECK THAT ROTOR ROTATES SMOOTHLY
REPLACEMENT
1. REPLACE BRUSHES
a. Unsolder and remove the brush and spring.
b. Run the wire of a new brush through the spring and the hole in the brush holder, and insert the spring and brush into the brush holder.