Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
e. Temporarily install these new terminal C kit parts:
1. Terminal insulator (inside)
NOTE: Be careful to Install the terminal insulator (inside) in the correct direction.
2. Contact plate
3. Terminal bolt
4. O-ring
5. Terminal insulator (outside)
6. Wave washer
7. Terminal nut
f.
Temporarily tighten the terminal nuts.
g. Tighten the terminal nuts.
1. Put a wooden block on the contact plate and press it down with a hand press.
Dimensions of wooden block: 20 x 37 x 40 mm (0.79 x 1.46 x 1.57 in.)
Press force: 981 N (100 kgf, 221 lbf)
NOTE:
Gauge Pressure
-
Check the diameter of the hand press ram. Then calculate the gauge pressure of the press when 981 N (100 kgf, 221 lbf) of force is
applied.
-
If the contact plate is not pressed down with the specified pressure, the contact plate may tilt due to coil deformation or the tightening
of the nut.