Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
1. MEASURE PS VANE PUMP ROTATING TORQUE
a. Check that the pump rotates smoothly without abnormal noise.
b. Using a torque wrench, check the pump rotating torque.
Rotating torque: 0.27 Nm (2.8 kgf-cm, 2.4 inch lbs.) or less
2. REMOVE VANE PUMP PULLEY
Using Special Service Tool (SST) to stop the pulley rotating, remove the pulley set nut.
SST 09960-10010 (09962-01000, 09963-01000)
3. REMOVE OIL RESERVOIR
a. Remove the 3 bolts and oil reservoir.
b. Remove the O-ring from the oil reservoir.
4. REMOVE PRESSURE PORT UNION, FLOW CONTROL VALVE AND SPRING
a. Remove the pressure port union, flow control valve and spring.
b. Remove the O-ring from the union.
5. REMOVE BRACKET
Remove the 2 bolts and bracket.
6. REMOVE REAR HOUSING
a. Remove the 2 bolts.
b. Remove the 2 O-rings from the rear housing.
7. REMOVE WAVE WASHER
8. REMOVE SIDE PLATE
9. REMOVE GASKET
10. REMOVE CAM RING, VANE PLATES AND VANE PUMP ROTOR
a. Remove the cam ring and 10 plates.
NOTICE: Take care not to drop the plate.
b. Using a screwdriver, remove the snap ring from the vane pump shaft.
c. Remove the vane pump rotor.
11. REMOVE VANE PUMP SHAFT
12. REMOVE STRAIGHT PINS
Remove the 2 pins from the front housing.
INSPECTION
NOTICE: When using a vise, do not overtighten it.