Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
NOTICE: When using a vise, do not overtighten it.
1. COAT PARTS INDICATED BY ARROWS WITH POWER STEERING FLUID
2. INSTALL STRAIGHT PINS
Using a plastic hammer, tap in 2 new straight pins to the front housing.
NOTICE: Be careful not to damage the pins.
3. INSTALL VANE PUMP SHAFT
4. INSTALL CAM RING
Install the cam ring with the inscribed mark facing outward.
HINT: Align the holes of the cam ring with the straight pins.
5. INSTALL VANE PUMP ROTOR
a. Install the rotor with the inscribed mark facing outward.
b. Install a new snap ring to the vane pump shaft.
6. INSTALL VANE PLATES
Install the 10 plates with the round end facing outward.
7. INSTALL GASKET
Install a new gasket on the front housing.