Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
/Page-946009.png)
4. INSPECT BEARING
a. Check the needle roller bearing of the rack housing for pitmarks or damage.
If faulty, replace the rack housing.
b. Coat the inside of the bearing with molybdenum disulfide lithium base grease.
5. INSPECT BEARING
a. Check the bearing rotation condition and check for abnormal noise.
If the bearing is worn or damaged, replace the control valve assembly.
b. Coat the bearing with molybdenum disulfide lithium base grease.
6. INSPECT BUSHING
a. Check the inside of the bushing of the cylinder end stopper for cracks.
If faulty, replace the bushing.
b. Coat the inside of the bushing with molybdenum disulfide lithium base grease.
7. IF NECESSARY, REPLACE BUSHING
a. Using a screwdriver, remove the bushing from the cylinder end stopper.
NOTICE: Be careful not to damage the cylinder end stopper.
b. Coat the inside of a new bushing with molybdenum disulfide lithium base grease.
c. Install the bushing.
8. IF NECESSARY, REPLACE TEFLON RING AND O-RING
