Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
DISPOSAL
1. FULLY EXTEND SHOCK ABSORBER ROD
2. DRILL HOLE TO DISCHARGE GAS FROM CYLINDER
Using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside.
CAUTION: The discharged gas is harmless, but be careful of chips which may fly up when drilling.
REPLACEMENT
1. REMOVE BUSHING
Using Special Service Tool (SST) and a press, remove the bushing.
SST 09506-35010, 09632-36010
2. INSTALL NEW BUSHING
Using SST and a press, install a new bushing.
SST 09506-35010, 09632-36010
HINT: Do not apply grease or oil to the bushing.
REASSEMBLY
1. INSTALL COIL SPRING TO SHOCK ABSORBER
a. Using Special Service Tool (SST) compress the coil spring.