Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
a. Using SST and a hammer, drive in a new oil seal.
SST 09950-60010 (09951-00350), 09950-70010 (09951-07100)
b. Install the output flange and 2 washers.
c. Install and torque a new nut.
Torque: 123 Nm (1,250 kgf-cm, 90 ft. lbs.)
HINT: Shift the shift lever to the P position.
d. Using a chisel and hammer, stake the nut.
7. INSTALL PROPELLER SHAFT
8. INSTALL DRAIN PLUG AND NEW GASKET
Torque: 20 Nm (205 kgf-cm, 15 ft. lbs.)
9. FILL ATF AND CHECK FLUID LEVEL