Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
c. Install the 2 removed bearing outer races to the spider.
d. Using SST, push out the bearing from the yoke.
SST 09332-25010
e. Clamp the outer bearing race in a vise and tap off the yoke with a hammer.
HINT: Remove the bearing on the opposite side in the same procedure.
5. SELECT SPIDER BEARING
Select the bearing according to whether or not there is a drill mark on the yoke section.
6. INSTALL SPIDER BEARING
a. Apply MP grease to a new spider and bearings.
NOTICE: Be careful not to apply too much grease.
b. Align the matchmarks on the yoke and shaft.
c. Fit the spider into the yoke.