Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
HINT: Pre runner is the model described .
RZN191L-TRPDKAB, RZN196L-CRPDKAB, PZN196L-PRPDKAB, VZN195L-CRPDKAB, VZN195L-PRPDKAB
1. REMOVE REAR WHEEL AND BRAKE DRUM
Torque: 110 Nm (1,150 kgf-cm, 83 ft. lbs.)
2. CHECK BEARING BACKLASH AND AXLE SHAFT DEVIATION
a. Using a dial indicator, check the backlash in the bearing shaft direction.
Maximum: 0.7 mm (0.028 inch)
If the backlash exceeds the maximum, replace the bearing.
b. Using a dial indicator, check the deviation at the surface of the axle shaft outside the hub bolt.
Maximum: 0.1 mm (0.0039 inch)
If the deviation exceeds the maximum, replace the axle shaft.
3. w/ ABS: REMOVE ABS SPEED SENSOR FROM REAR AXLE HOUSING
Remove the bolt and ABS speed sensor.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
4. REMOVE REAR BRAKE ASSEMBLY
5. DISCONNECT BRAKE LINE AND PARKING BRAKE CABLE