Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
a. Position the glass so that the reference marks are lined up, and press it in gently along the rim.
b. Using a spatula, apply adhesive on the glass rim.
c. Use a scraper to remove any excess or protruding adhesive.
d. Hold the glass in place securely with a protective tape or equivalent until the adhesive hardened.
NOTE: Take care not to drive the vehicle during the time described in the table.
10. INSPECT FOR LEAKS AND REPAIR
a. Conduct a leak test after the hardening time has elapsed.
b. Seal any leak with sealant.
Part No. 08833-00030 or equivalent
11. APPLY ADHESIVE TO MOULDING INSTALLATION AREA
Coat the glass with adhesive at the moulding installation area.
Part No. 08833-00030 or equivalent
12. INSTALL NEW WINDSHIELD OUTSIDE UPPER MOULDING
Place new moulding into the body and tap it by hand.
13. INSTALL WIPER ARMS