Tacoma PreRunner Extra Cab 2WD V6-3.4L (5VZ-FE) (2000)
2. Turn the ignition switch ON and push TOYOTA hand-held tester main switch ON.
NOTE: Do not start the engine.
3. Select the ACTIVE TEST mode on the TOYOTA hand-held tester.
4. Please refer to the TOYOTA hand-held tester operator's manual for further details.
5. If you have no TOYOTA hand-held tester, connect the positive (+) and negative (-) leads from the battery to the fuel pump connector.
6. Pinch the fuel return hose.
The pressure in the high pressure line will rise to approx. 400 kPa (4 kg/Sq.cm, 57 psi). In this state, check to see that there are no leaks
from any part of the fuel system.
NOTE: Always pinch the hose. Avoid bending as it may cause the hose to crack.
7. Turn the ignition switch OFF.
8. Disconnect the TOYOTA hand-held tester from the DLC3.