Tacoma PreRunner Extra Cab 2WD V6-3.4L (5VZ-FE) (2000)
Ignition Cable: Testing and Inspection
ON-VEHICLE INSPECTION
INSPECT HIGH-TENSION CORDS
a. Remove the air cleaner hose.
b. Disconnect the high-tension cords at the rubber boot. Do not pull on the high-tension cords.
NOTE: Pulling on or bending the cords may damage the conductor inside.
c. Using an ohmmeter, measure the high-tension cord resistance.
Maximum resistance: 25 kohms per cord
If the resistance is greater than maximum, check the terminals. If necessary, replace the high-tension cord.