Tacoma PreRunner Extra Cab 2WD V6-3.4L (5VZ-FE) (2000)
c. When connecting the flare nut on the high pressure pipe union, observe these procedures:
1. Apply a light coat of engine oil to the flare and tighten the flare nut by hand.
2. Using SST, tighten the flare nut to the specified torque.
SST 09631-22020
Torque: 28 Nm (285 kg.cm, 21 ft.lb)
HINT: Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
d. Observe these precautions when removing and installing the injectors.
1. Never reuse the O-ring.
2. When placing a new O-ring on the injector, take care not to damage it in any way.
3. Coat a new O-ring with spindle oil or gasoline before installing-never use engine, gear or brake oil.
e. Install the injector to the delivery pipe and intake manifold, as shown in the illustration.
f.
Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.
1. Connect a TOYOTA hand-held tester to the DLC3.