Tacoma PreRunner Extra Cab 2WD V6-3.4L (5VZ-FE) (2000)
d. Position the injector connector outward.
e. Place the 4 spacers in position on the intake manifold.
f.
Place the delivery pipes with the 6 injectors in position on the intake manifold.
g. Temporarily install the 4 bolts holding the delivery pipes to the intake manifold.
h. Check that the injectors rotate smoothly.
HINT: If injectors do not rotate smoothly, the probable cause is incorrect installation of O-rings. Replace the O-rings.
i.
Position the injector connector outward.
2. CONNECT INJECTOR CONNECTORS
3. INSTALL FUEL PIPE AND TIGHTENING DELIVERY PIPE HOLDING BOLTS
a. Install the fuel pipe with 4 new gaskets and the 2 union bolts.
Torque: 34.3 Nm (350 kg.cm, 25 ft.lb)
b. Tighten the 4 bolts holding the delivery pipes to the intake manifold.
Torque: 13 Nm (130 kg.cm, 10 ft.lb)