Tacoma PreRunner Extra Cab 2WD V6-3.4L (5VZ-FE) (2000)
Impact Sensor: Service and Repair
Removal and Installation
COMPONENT
REMOVAL
NOTE:
-
If the wiring connector of the SRS is disconnected with the ignition switch at ON or ACC position, DTCs will be recorded.
-
Never use SRS parts from another vehicle. When replacing parts, replace then with new parts.
-
Never reuse the sensor involved in a collision when the SRS has deployed.
-
Never repair a sensor in order to reuse it.
1. REMOVE BATTERY
a. Remove the bolt and battery clamp.
b. Remove the battery and battery carrier.