Tacoma PreRunner Reg Cab 2WD L4-2.7L (3RZ-FE) (1999)
4. IF NECESSARY, ADJUST FLUID PRESSURE
a. Adjust the length of the No. 2 shackle.
Low pressure - Lengthen A
High pressure - Shorten A
HINT: One turn of the nut changes the fluid pressure as shown in the table.
b. If the pressure cannot be adjusted by the No. 2 shackle, raise or lower the valve body.
Low pressure - Lower body
High pressure - Raise body
c. Torque the nuts.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
d. Adjust the length of the No. 1 shackle again.
If it cannot be adjusted, inspect the valve housing.
5. IF NECESSARY, CHECK VALVE BODY
a. Assemble the valve body in the uppermost position.
HINT: When the brakes are applied, the position will move down about 0.8 mm (0.03 inch). Even at this time, the piston should not make