Tacoma PreRunner Reg Cab 2WD L4-2.7L (3RZ-FE) (1999)
1. REMOVE DRIVE BELT
a. Loosen the power steering idle pulley set bolt.
b. Loosen the belt adjusting bolt.
2. DISCONNECT PRESSURE FEED TUBE
Using a spanner (24 mm) to hold the pressure port union, remove the union bolt and 2 gaskets.
3. DISCONNECT RETURN HOSE
NOTICE: Take care not to spill fluid on the drive belt.
4. REMOVE PS VANE PUMP ASSEMBLY
Remove the 2 pump assembly set bolts.
INSTALLATION
1. INSTALL PS VANE PUMP ASSEMBLY
Torque the 2 pump assembly set bolts.
Torque: 39 Nm (400 kgf-cm, 29 ft.lbs.)
2. CONNECT RETURN HOSE
3. CONNECT PRESSURE FEED TUBE
Torque the union bolt with a new gasket on each side of the tube.
Torque: 47 Nm (475 kgf-cm, 34 ft. lbs.)
HINT: Make sure the stopper of the tube is touching the PS pump body as shown, then torque the union bolt.
4. INSTALL DRIVE BELT
a. Tightening the belt adjusting bolt and adjust drive belt tension.
b. Torque the power steering idle pulley set nut.
Torque: 39 Nm (400 kgf-cm, 29 ft. lbs.)