Tacoma PreRunner Reg Cab 2WD L4-2.7L (3RZ-FE) (1999)
HINT: Pre-runner is the model described below.
RZN191L-TRPDKAB, RZN196L-CRPDKAB, VZN195L-CRPDKAB
1. REMOVE REAR WHEEL AND BRAKE DRUM
Torque: 110 Nm (1,150 kgf-cm, 83 ft. lbs.)
2. CHECK BEARING BACKLASH AND AXLE SHAFT DEVIATION
a. Using a dial indicator, check the backlash in the bearing shaft direction.
Maximum: 0.7 mm (0.028 inch)
If the backlash exceeds the maximum, replace the bearing.
b. Using a dial indicator, check the deviation at the surface of the axle shaft outside the hub bolt.
Maximum: 0.1 mm (0.0039 inch)
If the deviation exceeds the maximum, replace the axle shaft.
3. w/ ABS:
REMOVE ABS SPEED SENSOR FROM REAR AXLE HOUSING
Remove the bolt and ABS speed sensor.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
4. REMOVE REAR BRAKE ASSEMBLY