Tacoma Regular Cab 2WD L4-2.4L (2RZ-FE) (2000)
f.
Using a dial indicator near the center of the axle hub and measure the backlash in the bearing shaft direction.
Maximum: 0.05 mm (0.0020 inch) or less
9. INSTALL LOCK CAP, COTTER PIN AND GREASE CAP
a. Install the lock cap and a new cotter pin.
If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.
b. Install the grease cap.
10. INSTALL BRAKE CALIPER
Install the brake caliper with the 2 bolts.
Torque: 108 Nm (1,100 kgf-cm, 80 ft. lbs.)
11. w/ ABS: CONNECT ABS SPEED SENSOR AND WIRE HARNESS CLAMP TO STEERING KNUCKLE
Connect the ABS speed sensor and wire harness clamp with the 2 bolts.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
12. INSTALL FRONT WHEEL
Torque: 110 Nm (1,150 kgf-cm, 83 ft. lbs.)
13. DEPRESS BRAKE PEDAL SEVERAL TIMES
14. CHECK FRONT WHEEL ALIGNMENT
15. w/ ABS: CHECK ABS SPEED SENSOR SIGNAL