Tacoma Regular Cab 2WD L4-2.4L (2RZ-FE) (2000)
If the depth of wear is greater than the maximum, replace the contact plate.
c. Remove the terminal kit parts.
1. Using SST, loosen the terminal nuts.
SST 09810-38140
2. Terminal C:
Remove the terminal nut, wave washer, terminal insulator (outside), O-ring, terminal bolt, contact plate and terminal insulator (inside).
3. Terminal 30:
Remove the terminal nut, wave washer, terminal insulator (outside), packing, O-ring, terminal bolt, contact plate, terminal insulator (inside)
and insulation paper.
d. Temporarily install these new terminal 30 kit parts:
1. Insulation paper
2. Terminal insulator (inside)
NOTE: Be careful to install the terminal insulator (inside) in the correct direction.
3. Contact plate
4. Terminal bolt
5. O-ring
6. Packing and terminal insulator (outside)
Install the packing to the terminal insulator, and install them.
HINT: Match the protrusion of the insulator with the indentation of the housing.