Tacoma Regular Cab 2WD L4-2.4L (2RZ-FE) (2000)
Seals and Gaskets: Technical Service Bulletins
Drivetrain - Revised Rear Axle Oil Seal/Installation
DRIVELINE & DIFFERENTIAL
DL002-03
August 6, 2003
Title:
REAR AXLE SEAL DESIGN CHANGE
Models:
'01 - '02 Sequoia, '95 - '02 Tacoma &
'00 - '02 Tundra
Introduction
The rear axle seal lip design has been changed from a flat face type to an angled face type. A different SST seal driver is required to install the seal
properly and prevent damaging the oil seal during the installation process.
NOTE:
Use of SST part number 09951-00610 (Replacer 6-4) as listed in the Repair Manual to install the newly designed rear axle seal can damage the seal
assembly causing it to leak. Repair Manual update on Technical Information System (TIS) is in process.
Applicable Vehicles
^
2001 - 2002 model year Sequoia vehicles.
^
1995 - 2002 model year Tacoma vehicles.
^
2000 - 2002 model year Tundra vehicles.
Parts Information
Required SSTs
NOTE:
Additional SSTs may be ordered by calling SPX/OTC at 1-800-933-8335.
Required Tools & Material
Warranty Information
Identification Procedure