Tacoma Regular Cab 2WD L4-2438cc 2.4L DOHC MFI (1997)
(h) Connect SST (union and hose) to the injector, and hold the injector and union with SST (clamp). SST 09268-41046
(i) Put the injector into a graduated cylinder.
HINT: Install a suitable vinyl hose onto the injector to prevent gasoline from splashing out.
(j) Connect the TOYOTA hand-held tester to the DLC3.
(k) Turn the ignition switch ON and TOYOTA hand-held tester main switch ON.
NOTICE: Do not start the engine.
(l) Select the active test mode on the TOYOTA hand- held tester.
(m)Please refer to the TOYOTA hand - held tester operator's manual for further details.
(n) If you have no TOYOTA hand-held tester, connect the positive (+) and negative (-) leads from the battery to the fuel pump connector.
(o) Connect SST (wire) to the injector and battery for 15 seconds, and measure the injection volume with a graduated cylinder. Test each injector
2 or 3 times. SST 09842-30070
Volume:
62 - 79 cu.cm (3.8 - 4.8 Cu in.) per 15 seconds
Difference between each injector: 5 cu.cm (0.3 cu in.) or less
If the injection volume is not as specified, replace the injector.