Tacoma Regular Cab 2WD L4-2438cc 2.4L DOHC MFI (1997)
REMOVAL
1. Remove drive belt.
a. Loosen the power steering idle pulley set bolt.
b. Loosen the belt adjusting bolt.
2. Disconnect pressure feed tube. Using a 24 mm spanner to hold the pressure port union, remove the union bolt and 2 gaskets.
3. Disconnect return hose.
NOTICE: Take care not to spill fluid on the drive belt.
4. Remove PS vane pump assembly. Remove the 2 pump assembly set bolts.
INSTALLATION
1. Install PS vane pump assembly. Torque the 2 pump assembly set bolts.
Torque to 39 Nm (29 ft. lbs.)
2. Connect return hose.
3. Connect pressure feed tube. Torque the union bolt with a new gasket on each side of the tube.
Torque to 47 Nm (34 ft. lbs.)
HINT: Make sure the stopper of the tube is touching the PS pump body as shown, then torque the union bolt.