Tacoma Regular Cab 2WD L4-2438cc 2.4L DOHC MFI (1997)
Governor: Service and Repair
On-Vehicle Repair
REMOVAL
1. Remove extension housing.
2. Remove speedometer drive gear.
a. Using snap ring pliers, remove the snap ring.
b. Slide off the speedometer drive gear.
c. Remove the lock ball and outer snap ring.
3. Remove governor from output shaft.
a. Using a large screwdriver, remove the retaining clip.
b. Using a screwdriver unstake the lock plate, remove the bolt and lock plate.
Torque: 3.9 N.m (35 inch lbs.)
4. Remove governor body.
Remove the governor body from output shaft.
INSTALLATION HINT: Align the governor body and bolt hole on the output shaft.
INSTALLATION
Installation is in the reverse order of removal.