Tacoma Regular Cab 2WD L4-2438cc 2.4L DOHC MFI (1997)
d. Using SST 09930-00021 to hold the flange, press the bearing into position by tightening down a new nut.
Torque: 181 N.m (134 ft. lbs.)
e. Loosen the nut.
f.
Torque the nut again.
Torque: 69 N.m (51 ft. lbs.)
g. Using a chisel and hammer, stake the nut.
3. Install propeller shaft.
a. Align the matchmarks on the flanges and connect the flanges with 4 bolts, washers and nuts.
HINT: If replacing either the center flange or intermediate shaft, reassemble them so that the front flange yoke of the intermediate shaft and the
rear flange yoke of the propeller shaft are facing in the same direction.
b. Torque the bolts.
Torque: 74 N.m (54 ft. lbs.)