Tacoma Regular Cab 2WD L4-2438cc 2.4L DOHC MFI (1997)
8. Adjust preload.
a. Install and torque the nut.
Torque to 34 Nm (25 ft. lbs.)
b. Make the bearing smooth by turning the hub several times.
c. Loosen the nut until it can be turned by hand.
d. Using a spring tension gauge, measure and make a note of the frictional force of the oil seal.
HINT: Make sure to check preload in the direction of rotation.
e. Tighten the nut until the preload is within the specification.
Preload (at starting):
Frictional force plus 6 - 18 N (1.3 - 4.0 lbs.)
HINT: Make sure to check preload in the direction of rotation.
f.
Measure the hub axial play.
Axial play: 0.05 mm (0.0020 inch) or less.
9. Install lock cap, cotter pin and grease cap.
a. Install the lock cap and a new cotter pin.
b. Install the grease cap.
10. Install brake caliper. Install the 2 brake caliper set bolts.
Torque to 108 Nm (80 ft. lbs.)
11. w/ ABS: Connect ABS speed sensor and wire harness clamp to steering knuckle.
Torque to 8.0 Nm (71 inch lbs.).