Tercel/Cor. Tercel L4-1452cc 1AC,3A,3AC (1984)
Throttle Valve Cable/Linkage: Service and Repair
Removal
1.
Disconnect throttle cable from throttle linkage.
2.
Disconnect transaxle control cable from manual shift lever, then remove lever.
3.
Remove neutral safety switch, then the valve body as previously described.
4.
Remove cable retaining bolt, then the retaining plate.
5.
Pull cable from transaxle case.
Installation
1.
Insert cable into transaxle case, then install retaining plate and bolt.
2.
Install valve body as previously described, then position cable stop for adjustment reference as follows:
Fig. 6 Positioning throttle cable for installation
a. Bend cable to a radius of approximately 7.87 inches as shown, Fig. 6. Cable stop is not staked in place on replacement cable.
b. Lightly pull inner cable from housing until a slight resistance is felt, then hold in position.
c. Stake stopper onto inner cable so that .031-.059 inch clearance exists between stop and cable housing.
d. Connect and adjust throttle cable as previously described.
3.
Install neutral safety switch, then the manual shift lever. Adjust switch as previously described.
4.
Connect transaxle control cable.
5.
Ensure transaxle fluid level is to specifications, then road test vehicle.
