Tercel Sedan 2-Door L4-1456cc 1.5L SOHC (3E-E) (1991)
![background image](/toyota/tercel_sedan_2-door/l4-1456cc_1.5l_sohc_(3e-e)/Page-312003.png)
(a) Remove any old packing (FIPG) material and be careful not to drop any oil on the contact surfaces of the water pump and cylinder block.
-
Using a razor blade and gasket scraper, remove all the old packing (FIPG) material from the contact surfaces and sealing groove.
-
Thoroughly clean all components to remove all the loose material.
-
Using a non-residue solvent, clean both sealing surfaces.
(b) Apply seal packing to the water pump groove.
Seal packing: Part No.08826-00100, THREE BOND 1282B or equivalent
-
Install a nozzle that has been cut to a 2-3 mm (0.08-0.12 in.) opening.
HINT: Avoid applying an excessive amount to the surface.
-
Parts must be assembled within 5 minutes of application. Otherwise the material must be removed and reapplied.
-
Immediately remove nozzle from the tube and reinstall cap.
-
Do not pour in any coolant until at least 2 hours after installation is completed.
(c) Install the water pump with the bolt and 2 nuts.
Torque: 17 N.m (175 kgf.cm, 13 ft.lbf)
2. INSTALL OIL DIPSTICK GUIDE AND GENERATOR ADJUSTING BAR
(a) Install a new 0-ring to the dipstick guide.
(b) Apply soapy water to the 0-ring.