toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Compressor Speed Sensor, HVAC > < Wiring - Double Locking Type Connector 305 & 250 Series|Page 2580
Page 1
background image

Blower Motor Switch: Service and Repair

BLOWER SPEED CONTROL SWITCH SWITCH REMOVAL 

1. DISCONNECT NEGATIVE (-) CABLE FROM BATTERY.

2. REMOVE A/C CONTROL PANEL.

3. REMOVE AUDIO AND ASH TRAY.

4. REMOVE BLOWER SPEED CONTROL SWITCH.

(a) Remove the illumination light from the A/C control assembly.

(b) Using a screwdriver, pry loose the clip and push out the blower speed control switch to rear of the A/C control assembly.

(c) Disconnect the connector from the blower speed control switch.

Compressor Speed Sensor, HVAC > < Wiring - Double Locking Type Connector 305 & 250 Series|Page 2580