Tercel Sedan 2-Door L4-1497cc 1.5L DOHC (5E-FE) MFI (1997)
_mfi/Page-1404021.png)
1. Inspect the steering rack by using a dial indicator, check the rack for runout and teeth wear and damage. The maximum runout is 0.30 mm (0,0118
inch).
2. Using a micrometer and a cylinder gauge, measure the oil clearance between the control valve assembly and the bushing. The standard clearance
is 0.050 - 0.083 mm (0.00197 - 0.00327 inch) and the maximum clearance is 0.125 mm (0.00492 inch).
3. If necessary, replace the bushing and the oil seal by performing the following.
a. Using the 09612 - 65014 (09612 - 01030) Special Service Tool (SST) and two steel plates, remove the bushing from the rack housing.
NOTE: As shown, from the opposite aide of the SST confirm that its claw is firmly caught on the bushing. Be careful not to damage the rack
housing.
b. Using a brass bar and a hammer, remove the oil seal from the rack housing.
NOTE: Be careful not to damage the rack housing.
c. Coat a new oil seal lip with power steering fluid.