Tercel Sedan 4-Door L4-1456cc 1.5L SOHC (3E) (1994)
NOTICE: Removal and installation of the connector is done with the sensor assembly installed.
2. Using a torx wrench, loosen and tighten the 4 screws.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)
Torque: 13 N.m (130 kgf.cm, 9 ft.lbf)
NOTICE:
-
Make sure the sensor assembly is installed to the specified torque.
-
If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly
with a new one.
-
When installing the sensor assembly, take care that the airbag wiring does not interfere with other parts and is not pinched between other parts.
-
After installation, shake the sensor assembly to check that there is no looseness.