Tundra 2WD V6-3.4L (5VZ-FE) (2004)
21.
4WD:
Using the following SSTs and a press, install the bearing spacer.
SST P/N:
09950-60010
(09951-00650)
SST P/N:
09950-70010
(09951-07150)
22.
4WD:
Install new oil seal (inside).
A.
Using the following SST and a plastic hammer, install a NEW oil seal (inside).
SST P/N: 09527-17011
NOTE:
Lightly strike the SST on its circumference evenly.
B.
Coat MP grease to the oil seal lip.
23.
Install steering knuckle.
A.
4WD:
Insert the drive shaft into the axle hub and temporarily tighten the nut.
NOTE:
Be careful not to damage the oil seal and drive shaft boot.
B.
Connect the steering knuckle to the upper suspension arm.
C.
Install the nut and a NEW cotter pin. If the holes for the cotter pin are not aligned, tighten the nut further up to 600.
Torque: 105 N.m (1,100 kgf.cm, 77 ft.lbf)
24.
Connect the lower ball joint to the steering knuckle with 4 bolts.