Tundra 2WD V6-3.4L (5VZ-FE) (2004)
/Page-969001.png)
Yaw Rate Sensor: Service and Repair
YAW RATE SENSOR (w/ VSC)
REMOVAL
1. Passenger side: REMOVE FRONT SEAT
2. REMOVE YAW RATE SENSOR
a. Disconnect the connector.
b. Remove the 2 nuts and sensor.
INSTALLATION
^
Installation is in the reverse order of removal.
^
Check the yaw rate sensor zero point calibration. See: Antilock Brakes / Traction Control Systems/Testing and Inspection/Component Tests and
General Diagnostics/ABS W/EBD & BA & TRAC & VSC System/Zero Point Calibration of Yaw Rate and Deceleration Sensors
