Tundra 2WD V6-3.4L (5VZ-FE) (2004)
8. INSTALL CENTER CLUSTER INTEGRATION PANEL
a. When replacing the heater control assembly:
Pull off the cover.
b. Install the center cluster integration panel, then connect the 2 connectors.
c. Install the 5 screws.
d. Install the 3 heater control knobs.
Disassembly and Reassembly
HEATER CONTROL ASSEMBLY
DISASSEMBLY
1. REMOVE HEATER CONTROL CABLES
a. Using a screwdriver, spread the claw of the cable clamp and disconnect the outer cable.
HINT: Tape the screwdriver tip before use.
b. Remove the inner cable from the heater control assembly.
2. REMOVE BLOWER SPEED CONTROL SWITCH
a. Disconnect the connector.
b. Remove the 2 screws.
c. Remove the switch.