Tundra 2WD V6-3.4L (5VZ-FE) (2004)
![background image](/toyota/tundra_2wd/v6-3.4l_(5vz-fe)/Page-106001.png)
Wheel Speed Sensor: Service and Repair
Speed Sensor, Rear
REAR SPEED SENSOR
REMOVAL
1. DISCONNECT SPEED SENSOR CONNECTOR
2. REMOVE SPEED SENSOR
a. Remove the 2 clamp bolts, clamp nut and 5 resin clips holding the sensor wire harness from the axle and the fuel tank.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
HINT:
^
When installing the rear sensor wire harness, never use the removed resin clips, which are service parts.
^
When replacing clips, set up new resin clips at the same angle of the removed resin clips.
b. Remove the bolt and speed sensor from the axle carrier.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
INSTALLATION
Installation is in the reverse order of removal.
HINT: After installation, check speed sensor signal.