Tundra 2WD V6-3.4L (5VZ-FE) (2004)
1. Using the SST, connect terminals Tc (13) and CG (4)of the DLC3.
SST 09843-18040
2. Turn the ignition switch ON.
HINT: Keep the vehicle in the stationary condition with the shift lever in the P position.
3. After turning the ignition switch ON, check that the VSC warning light is illuminated for about 4 seconds and then starts quick blinking at 0.13
second intervals.
4. After ensuring that the VSC warning light is blinking for 2 seconds and the ignition switch is turned OFF.
5. Remove the SST and disconnect terminals Tc (13) and CG (4) of the DLC3.
SST 09843-18040