Tundra 2WD V6-3.4L (5VZ-FE) (2004)
4. REMOVE RH AND LH CLIPS, RACK BOOTS AND CLAMPS
a. Using a screwdriver, loosen the 2 clamps.
b. Remove the 2 clips and boots.
HINT: Mark the RH and LH boots.
NOTICE: Be careful not to damage the boot.
5. REMOVE RH AND LH RACK ENDS AND CLAW WASHERS
a. Using a screwdriver and hammer, unstake the washer.
NOTICE: Avoid any impact on the steering rack.
b. Using a spanner to hold the steering rack steadily, and using SST, remove the rack end.
SST 09922-10010
HINT: Mark the RH and LH rack ends.
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
c. Remove the washer from the rack end.
d. Employ the same manner described above to the other side.
6. REMOVE RACK GUIDE SPRING CAP LOCK NUT
Using SST, remove the lock nut.