Tundra 2WD V6-3.4L (5VZ-FE) (2004)
/Page-1143005.png)
HINT: Fit the lower end of the coil spring into the gap of the spring seat of the shock absorber.
2. INSTALL SUSPENSION SUPPORT
a. Install the cushion, 2 retainers and suspension support to the piston rod.
b. Temporarily tighten a new suspension support center nut.
c. Position the suspension support as shown in the illustration.
d. Remove the SST.
SST 09727-30021 (09727-00010, 09727-00021, 09727-00031)
NOTICE: Do not make your position at the top side of the shock absorber.
HINT: After removing the SST, recheck the direction of the suspension support.
e. Torque the suspension center nut.
Torque: 25 Nm (250 kgf-cm, 18 ft. lbs.)