Tundra 2WD V6-3.4L (5VZ-FE) (2004)
Universal Joint: Service and Repair
Disassembly and Reassembly
DISASSEMBLY
NOTICE: Be careful not to grip the propeller shaft tube too tightly in a vise as this will cause deformation.
1. SEPARATE PROPELLER SHAFT AND INTERMEDIATE SHAFT
a. Place matchmarks on the yoke and propeller shaft.
b. Disassemble center yoke.
2. REMOVE CENTER SUPPORT BEARING FROM INTERMEDIATE SHAFT
a. Using a hammer and chisel, loosen the staked part of the nut.
b. Clamp the yoke in a vise and remove the spacer and nut.