Tundra 2WD V6-4.0L (1GR-FE) (2005)
B. Remove the 4 bolts retaining the transmission to the rear transmission mount.
C. Remove the 4 bolts retaining the frame crossmember No.3 to the frame assembly and remove the frame crossmember No.3 assembly with rear
transmission mount from the vehicle.
NOTE
Do NOT torque any of the bolts in steps D through F until ALL the bolts in steps D through F have been started.
D. Install the NEW rear transmission mount (insulator engine mounting rear) to the transmission extension housing using the 4 bolts.
Torque: 65 N*m (660 kgf*cm, 48 ft*lbf)