toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

A/T - Clunk/Pop/Thunk On Acceleration Or Stopping|Page 7256 > < A/T - Clunk/Pop/Thunk On Acceleration Or Stopping|Page 7250
Page 1
background image

Cross-Member: Customer Interest
A/T - Clunk/Pop/Thunk On Acceleration Or Stopping

T-SB-0067-09

February 19, 2009

Clunk Noise at Low Speeds when Stopping or Turning

Service Category
Drivetrain

Section
Automatic Transmission/Transaxle

Market
USA

Applicability

Introduction

Some customers of 2WD 2005 - 2007 model year Sequoia and 2005 - 2006 model year Tundra vehicles may complain about a clunk thunk or pop noise
from the vehicle that is commonly heard when stopping accelerating from a stop or turning at low speeds. The source of the noise has been identified as
the joint between the rear transmission mount and the frame crossmember. The transmission mount has been redesigned to prevent this. Use the
following repair procedure to address customer concerns.

Warranty Information

APPLICABLE WARRANTY

^ This repair is covered under the Toyota Powertrain Warranty. This warranty is in effect for 60 months or 60,000 miles, whichever occurs first, from

the vehicle's in-service date.

^ Warranty application is limited to correction of a problem based upon a customer's specific complaint.

A/T - Clunk/Pop/Thunk On Acceleration Or Stopping|Page 7256 > < A/T - Clunk/Pop/Thunk On Acceleration Or Stopping|Page 7250