Tundra 2WD V6-4.0L (1GR-FE) (2005)
h. Using SST, remove the oil filter.
SST 09228-07501
i.
Remove the drain hose and install the drain pipe cap.
j.
Clean the oil catch plate.
3. INSTALL OIL FILTER
a. Clean the oil filter contact surface on the oil filter bracket.
b. Lubricate the rubber gasket of a new oil filter with clean engine oil.
c. Tighten the oil filter by hand until the rubber gasket contacts the seat of the filter bracket.
d. Using SST, give it an additional 3/4 turn to set the filter.
SST 09228-07501
4. ADD ENGINE OIL
a. Fill with new engine oil.
Capacity:
Drain and refill: w/ Oil filter change: 4.5 liters (4.8 US qts., 4.0 Imp. qts.)
w/o Oil filter change: 4.2 liters (4.4 US qts., 3.7 Imp. qts.)
Dry fill: 5.6 liters (5.9 US qts., 4.9 Imp. qts.)
b. Reinstall the oil filler cap.
5. CHECK FOR ENGINE OIL LEAKS
6. CHECK ENGINE OIL LEVEL