Tundra 2WD V6-4.0L (1GR-FE) (2005)
Blower Motor Resistor: Testing and Inspection
BLOWER RESISTOR
INSPECTION
1. REMOVE GLOVE COMPARTMENT PARTS
2. REMOVE LOWER NO.2 FINISH PANEL
3. REMOVE LOWER CENTER COVER
4. REMOVE LOWER LH FINISH PANEL
5. REMOVE LOWER COVER
6. REMOVE NO.4 HEATER TO REGISTER DUCT
7. REMOVE BLOWER RESISTOR
a. Disconnect the connector.
b. Remove the 2 screws and blower resistor.
8. INSPECT BLOWER RESISTOR RESISTANCE
If resistance is not as specified, replace the blower resistor.
9. INSTALL BLOWER RESISTOR
a. Install the blower resistor with the 2 screws.