Tundra 2WD V6-4.0L (1GR-FE) (2005)
Evaporator Case: Testing and Inspection
Inspection
INSPECTION
1. CHECK EVAPORATOR FINS FOR BLOCKAGE
If the fins are clogged, clean them with compressed air.
2. CHECK FITTING FOR CRACKS OR SCRATCHES
If necessary, repair or replace.
3. INSPECT THERMISTOR RESISTANCE
a. Remove the A/C evaporator temperature sensor (cooler thermistor No.1).
b. Measure the resistance according to the value(s) in the table.
NOTE:
-
Even slightly touching the sensor may change the resistance value. Be sure to hold the connector of the sensor.
-
When measuring, the sensor temperature must be the same as the ambient temperature.