Tundra 2WD V6-4.0L (1GR-FE) (2005)
1. PRECAUTION
Refer to Air Bag Systems; Service Precautions.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
3. REMOVE LOWER FINISH PANEL
4. REMOVE SWITCH BASE
a. Using a screwdriver, remove the 3 claws and switch base.
HINT: Tape up the screwdriver tip before use.
b. Disconnect the connectors.
INSTALLATION
1. INSTALL SWITCH BASE
a. Connect the connectors.
b. Install the switch base.
2. INSTALL LOWER FINISH PANEL
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. INSPECT SRS WARNING LIGHT
Replacement
REPLACEMENT
REPLACEMENT REQUIREMENTS
In the following cases, replace the wire harness or connector with a new one.
-
Any of the SRS wire harness and connectors has been found to be faulty in troubleshooting.
-
Any of the SRS wire harness and connectors has been found to be faulty while checking items
CAUTION: If the wire harness used in the SRS is damaged, see Removal and Installation. replace the whole SRS wire harness assembly.