Tundra 2WD V6-4.0L (1GR-FE) (2005)
3. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY
a. Install the plate seal (Inside).
b. Place the brush holder with the pin facing upward.
NOTE: Be careful of the brush holder installing direction.
c. Install the 2 screws.
Torque: 1.8 N.m (18 kgf.cm, 16 in.lbf)
d. Align the pins of the brush holder with the holes of the plate seal (outside), and install the plate seal (outside).
4. INSTALL TERMINAL INSULATOR
5. INSTALL GENERATOR REAR END COVER
a. Install the rear end cover with the 3 nuts.
Torque: 4.6 N.m (47 kgf.cm, 41 in.lbf)